Hohmann & Barnard HB-213 Adjustable Veneer Anchor – 14 Ga Hot-Dip Galvanized

HB-213 ADJUSTABLE VENEER ANCHOR 

HB-213 Adjustable Veneer Anchor Only, 2X-HOOK Sold Separately 

The HB-213 is a high-performance, adjustable veneer anchor designed for use in cmu/concrete backing, metal stud and wood stud construction. It is used with with the 2X-HOOK (sold separately), which has been rigorously tested to withstand over 200-lbf in tension or compression, at the maximum allowable offset of 1-1/4”. This results in performance exceeding industry standards, outperforming typical round wire hooks or pintles by over 100%. The anchor's design includes an L-shaped plate section with added ribs for strength, along with holes for connecting screws.

FEATURES

• High Load Capacity: Tested to withstand over 200-lbf in tension or compression with a maximum allowable offset of 1-1/4”
• Robust Design: Includes an L-shaped plate section with ribs for added strength
• Compatible with 2X-HOOK: The 2X-HOOK (sold separately) can be installed with legs pointing up or down
• Ideal for Various Backups: Suitable for concrete, CMU, or brick backup, with a specific version (HB-5213) for these applications
• Seismic Reinforcement Options: Optional Seismiclip Interlock System (HB-213 S.I.S.), Seismic Hook (HB-213 SH), or Welded Seismic Clip (Seismic Clip 300C w/HB-213) for seismic compliance
• Patent-Pending Design: The 2X-HOOK is covered under U.S. Patent No. 8,613,175

DIMENSIONS

• Gauge Options: 14 gauge 
• Material Finish: Hot-dip Galvanized

APPLICATIONS

• Veneer Anchoring: Specifically designed for attaching brick veneer to stud backup systems
• Seismic Reinforcement: Optional seismic options available for additional stability

NOTES

• Spacing: H&B recommends 16" x 16" spacing for optimal performance
• Accommodates Insulation and Wallboard: Legs are designed to accommodate up to 6" thick insulation and/or wallboard combinations (please specify thickness when ordering)
• Wind-Load Management: The HB-200-X variant includes pronged punch-outs to manage positive wind-loads by transferring the load to the back of the stud, preventing damage to wallboard.
• The 2X-HOOK is sold separately, and installation requires the use of pintle hooks for full setup.
  
• Optional: HB-213 Washer to hold insulation to back-up

RESOURCES

• Submittal
• HB-213 Wood Stud Installation Video
• HB-213 Metal Stud Installation Video
• HB-213 CMU/Concrete Installation Video
• Safety Data Sheet Hot Rolled Carbon Steel
• Safety Data Sheet Galvanized Steel Sheet
• Safety Data Sheet Bright Basic Wire
• Safety Data Sheet Hot-Dip Galvanized Coating
• Safety Data Sheet Stainless Steel
• LEED HB-213